Controller Clip (Carbon V1) was inspired to replace your existing ashtray with a needed utility of organizing headset controllers. Simply remove your ashtray and utilize existing screws to secure Controller Clip. Controller Clips are 3D printed in Carbon Fiber infused PETG. PETG is an engineering grade filament that is heat resistant and great for the application at hand.
Supports various headset models with ANR Controllers. Chose option on checkout.
This unit was designed for a Cessna 172 but confirmation has been made that it will also fit a Cessna 182. However, as variations have known to exist, I would suggest verifying measurements prior to placing order. See photos for measurements. If you require a specific size not listed, please reach out and modifications can be made to accommodate.
Non PMA'd parts and no STC has been obtained. Owner assumes all liability for installation.
"As orders are 3D printed and assembled upon purchase, please allow up to two weeks for shipment!"
Cessna Controller Clip (Carbon V1)
- Material is heat resistant Carbon Fiber PETG for all 3D printed parts.
- Package comes in three pieces.
- Backplate and support arm comes in two pieces so that you can access through the hole in the backplate to reach behind the side panel to secure screws and blind nut, etc.
- Non PMA'd parts and no STC has been obtained. Owner assumes all liability for installation.