top of page

Controller Clip (Carbon V3) was inspired to replace your existing ashtray with a needed utility of organizing headset controllers. However, request were made from the group so we added a pen holder and headset hook as well.  Pen holder-endcap is TPU Rubber to conform and secure pens in place.  Option provided for Rubber Strap to secure headset for those turbulent moments.

 

Simply remove your ashtray and utilize existing screws to secure Controller Clip. Controller Clips are 3D printed in Carbon Fiber infused PETG. PETG is an engineering grade filament that is heat resistant and great for the application at hand.

 

Supports Bose A20/30 & Lightspeed (Zulu 3/Sierra) ANR Controllers.

 

This unit was designed for a Cessna 172 but confirmation has been made that it will also fit a Cessna 182.  However, as variations have known to exist, I would suggest verifying measurements prior to placing order. See photos for measurements. If you require a specific size not listed, please reach out and modifications can be made to accommodate.

 

"As orders are 3D printed and assembled upon purchase, please allow up to two weeks for shipment!"

 

Cessna Controller Clip (Carbon V3)

$65.00Price
    1. Material is heat resistant Carbon Fiber PETG for all 3D printed parts.
    2. Package comes in three pieces.
    3. Backplate and support arm comes in two pieces so that you can access through the hole in the backplate to reach behind the side panel to secure screws and blind nut, etc.
    4. Non PMA'd parts and no STC has been obtained. Owner assumes all liability for installation.
bottom of page